04.17.25 (25-008) AN ORDINANCE TO AMEND INDSTRIAL SETBACKSAN ORDINANCE TO AMEND THE FOLLOWING SECTIONS OF APPENDIX B. ZONING:
ARTICLE IV (ZONING DISTRICTS AND BOUNDARIES), SECTION 4-11005.0 LIMITED
INDUSTRIAL - BULK REGULATIONS, MINIMUM SETBACK REQUIREMENTS,
SECTION 4-12005.0 GENERAL INDUSTRIAL — BULK REGULATIONS, MINIMUM
SETBACK REQUIREMENTS, SECTION 4-13005.B GENERAL INDUSTRIAL
CONSERVATION — BULK REGULATIONS, MINIMUM SETBACK REQUIREMENTS, AND
ARTICLE V (SUPPLEMENTARY USE REGULATIONS), SECTION 5-2000.1-11,
SUPPLEMENTARY DENSITY AND DIMENSIONAL REGULATIONS, PROJECTIONS AND
YARD SETBACK MODIFICATIONS
IN ORDER TO INCREASE SETBACK REQUIREMENT FOR INDUSTRIAL USES
ADJACENT TO EXISTING RESIDENTIAL PROPERTIES AND TO EXEMPT UTILITY
CABINETS FROM MEETING MINIMUM YARD SETBACK REQUIREMENTS
WHEREAS, the Board of Supervisors of Isle of Wight County, Virginia, has the legislative
authority to make reasonable changes to the ordinances that govern the orderly growth and development
of Isle of Wight County; and
WHEREAS, the Isle of Wight County Board of Supervisors is also concerned about the
compatibility of uses on public and private lands within Isle of Wight County and seeks to allow
flexibility in the administration of the ordinance regulations while protecting the health, safety, and
general welfare of present and future residents and businesses of the County.
NOW, THEREFORE, BE IT ORDAINED by the Isle of Wight County Board of Supervisors
that the following sections of Appendix B. Zoning: Article IV (Zoning Districts and Boundaries) and
Article V (Supplementary Use Regulations) of the Isle of Wight County Code be amended and reenacted
as follows:
Sec. 4-11005. Limited Industrial - Bulk regulations
C. Minimum setback requirements:
1. Front yard: Thirty-five (35) feet.
a. Industrial uses shall meet a setback of one hundred (100) feet, except that office
buildings associated with the industrial use may meet the minimum thirty-five (35) feet
setback.
b. For lots within designated industrial park of twenty (20) acres or more, office buildings
associated with the industrial use shall meet a setback of thirty-five (35) feet.
2. Side yard: Twenty (20) feet.
3. Rear yard: Twenty (20) feet.
4. For parcels directly adjacent to an existing residential subdivision of at least five lots recorded
on the same plat as of July 1, 2025, the minimum setback for new industrial uses consisting of
one building shall be 100 feet and 200 feet for industrial uses with two or more buildings, not
including accessory buildings, from the side and rear property line adjacent to the residential
subdivision. Within the required setback, there shall be no development, clearing, grading, or
construction activity with the following exceptions:
a. Roadway or driveway access to the portion of the site not in the minimum residential setback
is permitted provided that it is approximately perpendicular to the arterial public right-of-
way;
b. Water, sanitary sewer, stone drainage, to include stormwater management ponds, electrical,
telephone, natural cable, and utility service lines may be installed below the surface of the
ground at right angles, provided that the natural vegetation is preserved and protected to the
greatest extent practicable, and landscaping requirements are met;
c. Sidewalks, pedestrian pathways and bicycle paths designed to provide continuous connection
along the road corridor may be permitted, provided that they can be constructed without
materially reducing the screening and visual softening capacity of the required landscaping;
d. Signs are permitted in accordance with article IX;
e. Clearing for sight distances is permitted at the entrances and exits to any development as
needed to provide for reasonable traffic safety, in accordance with accepted traffic
engineering practices recommended or required by the Virginia Department of
Transportation;
f. The trimming of existing limbs or branches of preserved trees is permitted when approved by
the zoning administrator;
g. There shall be an earthen berm with a minimum height of ten (10) feet installed in the
required setback between the residential use and the industrial use in addition to a minimum
of three rows of staggered evergreen landscaping planted a maximum of ten feet on center.
h. A sound study shall be required with the submittal of the application for the industrial use.
The new development shall implement a sound wall or other mitigation measure as
recommended in the study in addition to the berm and landscaping requirements as approved
by the Zoning Administrator.
i. The board of supervisors may exempt, wholly or partially, any new proposed industrial
development adjacent to existing residential subdivisions from the requirements of this
section. In granting exemptions, the board of supervisors with a recommendation by the
planning commission may impose reasonable conditions.
Sec. 4-12005. General Industrial — Bulk regulations
C. Minimum setback requirements:
i. Front yard: Thirty-five (35) feet.
a. Industrial uses shall meet a setback of one hundred (100) feet, except that office buildings
associated with the industrial use may meet the minimum setback of thirty-five (35) feet.
b. For lots within designated industrial park of twenty (20) acres or more, office buildings
associated with the industrial use shall meet a setback of thirty-five (35) feet.
2. Side yard: Twenty (20) feet.
3. Rear yard: Twenty (20) feet.
4. For parcels directly adjacent to an existing residential subdivision of at least five lots recorded
on the same plat as of July 1, 2025, the minimum setback for new industrial uses consisting of
one building shall be 100 feet and 200 feet for industrial uses consisting of two more buildings,
not including accessory buildings, from the side and rear property line adjacent to the residential
subdivision. Within the required setback, there shall be no development, clearing, grading, or
construction activity with the following exceptions:
a. Roadway or driveway access to the portion of the site not in the minimum residential
setback is permitted provided that it is approximately perpendicular to the arterial public
right-of-way;
b. Water, sanitary sewer, storm drainage, to include stormwater management ponds, electrical,
telephone, natural cable, and utility service lines may be installed below the surface of the
ground at right angles, provided that the natural vegetation is preserved and protected to the
greatest extent practicable, and landscaping requirements are met;
c. Sidewalks, pedestrian pathways and bicycle paths designed to provide continuous
connection along the road corridor may be permitted, provided that they can be constructed
without materially reducing the screening and visual softening capacity of the required
landscaping;
d. Signs are permitted in accordance with article IX;
e. Clearing for sight distances is permitted at the entrances and exits to any development as
needed to provide for reasonable traffic safety, in accordance with accepted traffic
engineering practices recommended or required by the Virginia Department of
Transportation;
f. The trimming of existing limbs or branches of preserved trees is permitted when approved
by the zoning administrator;
g. There shall be an earthen berm with a minimum height of ten (10) feet installed in the
required setback between the residential use and the industrial use in addition to a minimum
of three rows of staggered evergreen landscaping planted a maximum of ten feet on center.
h. A sound study shall be required with the submittal of the application for the industrial use.
The new development shall implement a sound wall or other mitigation measure as
recommended in the study in addition to the berm and landscaping requirements as
approved by the Zoning Administrator.
i. The board of supervisors may exempt, wholly or partially, any new proposed industrial
development adjacent to existing residential subdivisions from the requirements of this
section. In granting exemptions, the board of supervisors with a recommendation by the
planning commission may impose reasonable conditions.
Sec. 4-13005. General Industrial Conservation — Bulk regulations
B. Minimum setback requirements:
1. Front yard: Thirty-five (35) feet.
a. Industrial uses shall meet a setback of one hundred (100) feet from the right-of-way of
any existing street which abuts or borders the use, except that uses located within a
designated industrial park of twenty (20) acres or more shall meet a setback of fifty (50)
feet from any street right-of-way.
b. For lots within a designated industrial park of twenty (20) acres or more, office
buildings associated with the industrial use shall meet a setback of thirty-five (35) feet.
2. Side yard: Twenty (20) feel.
3. Rear yard: Twenty (20) feet. (I 1- l 7-16; 7-19-18; l 1-15- l 8. )
4. For parcels directly adjacent to an existing residential subdivision of at least five lots recorded
on the same plat as of July 1, 2025, the minimum setback for new industrial uses consisting of
one building shall be 100 feet and 200 feet for industrial uses with two or more buildings, not
including accessory buildings, from the side and rear property line adjacent to the residential
3
subdivision. Within the required setback, there shall be no development, clearing, grading, or
construction activity with the following exceptions:
a. Roadway or driveway access to the portion of the site not in the minimum residential setback
is permitted provided that it is approximately perpendicular to the arterial public right-of-
way;
b. Water, sanitary sewer, storm drainage, including stormwater management ponds, electrical,
telephone, natural cable, and utility service lines may be installed below the surface of the
ground at right angles, provided that the natural vegetation is preserved and protected to the
greatest extent practicable, and landscaping requirements are met;
c. Sidewalks, pedestrian pathways and bicycle paths designed to provide continuous connection
along the road corridor may be permitted, provided that they can be constructed without
materially reducing the screening and visual softening capacity of the required landscaping;
d. Signs are permitted in accordance with article IX;
e. Clearing for sight distances is permitted at the entrances and exits to any development as
needed to provide for reasonable traffic safety, in accordance with accepted traffic
engineering practices recommended or required by the Virginia Department of
Transportation;
f. The trimming of existing limbs or branches of preserved trees is permitted when approved by
the zoning administrator;
g. There shall be an earthen berm with a minimum height of ten (10) feet installed in the
required setback between the residential use and the industrial use in addition to a minimum
of three rows of staggered evergreen landscaping planted a maximum of ten feet on center.
h. A sound study shall be required with the submittal of the application for the industrial use.
The new development shall implement a sound wall or other mitigation measure as
recommended in the study in addition to the berm and landscaping requirements as approved
by the Zoning Administrator.
i. The board of supervisors may exempt, wholly or partially, any new proposed industrial
development adjacent to existing residential subdivisions from the requirements of this
section. In granting exemptions, the board of supervisors with a recommendation by the
planning commission may impose reasonable conditions.
Sec. 5-2000. - Supplementary density and dimensional regulations.
H. Projections and yard setback modifications.
1. Covered, unenclosed front porches. Covered, unenclosed porches, decks, landings, steps,
terraces, patios or platforms, open on three (3) sides except for necessary supporting columns
and customary architectural features, may be permitted in a required front yard provided that
such structure shall not be more than eight (8) feet in width and shall not project more than three
(3) feet into such yard.
2. Covered unenclosed porches permitted in required side or rear yard. Covered, unenclosed
porches, decks, landings, steps, terraces, patios or platforms, open on three (3) sides except for
necessary supporting columns and customary architectural features, may be permitted in
required side or rear yards provided that no such structure, shall project closer than three (3) feet
to any side lot line, that no such structure shall be more than one (1) story in height or more than
twenty-four (24) feet in length, and that no such structure shall project more than eight (8) feet
into any required rear yard.
4
3. Uncovered porches. Uncovered porches, decks, landings, steps, terraces, patios or platforms
which do not extend above the level of the first floor of the building (except for railings and
railing supports) may project into any required front, side or rear yard or court not to exceed
eight (8) feet.
4. [Architectural features, chimneys, air conditioners, cornices, eaves, belt courses, sills, canopies,
or other similar architectural features.) Architectural features, chimneys, air conditioners,
generators, fuel tanks, cornices, eaves, belt courses, sills, canopies, or other similar architectural
features (but not including bay windows or vertical projections) may project into a required side
yard not more than eighteen (18) inches, but not closer than three (3) feet to the side lot line,
and may not exceed thirty-six (36) inches. Chimneys and air conditioners may project into any
yard not more than eighteen (18) inches, but air conditioners rated at twenty-four thousand
(24,000) BTU or less shall not be so placed as to discharge air within five (5) feet of side yard
lines, and those rated over twenty-four thousand (24,000) to discharge air within twelve (12)
feet of side yard lines, other than side yard lines adjacent to streets.
5. Open fire escapes. Open, unenclosed fire escapes may project not more than four (4) feet into
any required yard, but shall not project closer than three (3) feet to any side lot line.
6. Open stairways and balconies. Open, unenclosed stairways or balconies, not covered by a roof
or canopy, may extend or project into a required rear yard only, not more than four (4) feet, but
shall not be within three (3) feet of any property line.
7. Exemption of front yard setback for handicap ramps. Handicap ramps used for residence(s) of a
single-family dwelling shall be allowed to encroach into the required front yard setback. The
ramp must be built in accordance with the American Disabilities Act as it pertains to wheelchair
accessibility. In no instance shall the ramp be covered.
8. Exemption of yard setback requirements for electrical, water or wastewater utility cabinets.
Utility cabinets measuring no more than six feet high and eight feet wide shall be allowed to
encroach into required yard setbacks and shall be located outside of any required sight line or
sight triangle.
DATE:
1
r�
READ AND PASSED:
Chairman .. ..-.. -----------
TESTE. _
crk ,
Approved as to F
Robert
Attorney